Ge-industrial-solutions EntelliGuard G Bell Alarm W_ Lock-out Bedienungsanleitung PDF herunterladen

Introduction

Bell Alarm W/ Lock-out:

The bell alarm contact is used to indicate the

circuit breaker has tripped due to an electrical

fault. This device can only be installed in a

EntelliGuard G breaker with an EntelliGuard trip

unit that has a manual lockout feature. Trip unit

catalogs with a "M" in the 10th position indicates

the manual lockout feature, for example

GGN04L3XMFXXXX. In the case of an over

current the bell alarm will be activated and the

breaker cannot be re-closed until the reset button

on the trip unit has been reset. If the 10th digit

on the Trip Unit is A, S, or X then a Trip Unit will

also need to be ordered.

Electrical characteristics Bell Alarm Contact

Table 1. Catalog Numbers and Ratings

AC Ratings

Voltage Amps

120V AC 6A

250V AC 6A

Cat no: GBAT1R

DEH-41409 Installation Instructions

EntelliGuard

G Circuit Breaker

Accessories

Bell Alarm W

Lock-out

WARNING: Before installing any accessories, turn the

breaker OFF, disconnect it from all voltage sources,

and discharge the closing spings.

AVERTISSEMENT: Avant d’installer tout accessoire,

mettre le disjoncteur en position OFF, le déconnecter

de toute tension d’alimentation , et décharger les

resorts d’armement

Use the following procedure to install the Bell

Alarm accessory into the circuit breaker.

1. Verify that the rating on the Bell Alarm

identification plate matches the voltage rating

required for the application, as listed in Table 1.

2. Turn the breaker off and discharge the closing

springs by depressing the OFF and ON buttons in

the sequence OFF-ON-OFF. Verify that the

breaker OFF-ON indicator shows OFF on a green

background and that the charge indicator shows

DISCHARGE on a white background. If installing

in a draw-out type breaker remove breaker from

adaptor (cassette) before continuing.

3. Loosen the 6 screws on front cover (fascia)

using a posidrive screw driver as shown in Fig 1.B

Rotate the charging handle down and slide the

front cover over the handle to remove the front

cover as shown in Fig. 1.C.

1 2 3 4

Inhaltsverzeichnis

Seite 1

Introduction Bell Alarm W/ Lock-out: The bell alarm contact is used to indicate the circuit breaker has tripped due to an electric

Seite 2

Figure 1. (A) Front Cover (B) ScrewRemoval (C) Handle Rotation 4. Remove the trip unit from the PMU base. 5. While holding the switch lever, s

Seite 3

11. Ensure the fascia is aligned properly with the trip unit and the pad lock features of the breaker. 12. Fasten the 6 mounting screws of fascia

Seite 4

Reference: Bell Alarm Connection Scheme: These instructions do not purport to cover all details or variations in equipment nor,

Kommentare zu diesen Handbüchern

Keine Kommentare

Ge-industrial-solutions EntelliGuard G Bell Alarm W_ Lock-out Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Ausrüstung Ge-industrial-solutions EntelliGuard G Bell Alarm W_ Lock-out herunter. GE Industrial Solutions EntelliGuard G Bell Alarm W_ Lock-out User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Ge-industrial-solutions EntelliGuard G Bell Alarm W_ Lock-out